Smittybilt 76810 XRC Multi Optional Design (M.O.D.) Front Bumpe

The all new line of Smittybilt XRC bumpers for the 84-01 Jeep Cherokee was engineered to provide maximum ground clearance. Manufactured out of 3/16" cold rolled steel that is robotically welded to exact specifications. The front bull bar is manufactured from 1.75" tubing and has two light tabs that can accommodate up to a 9" light. Its unique design is capable of mounting up to a 12,000 lb. winch. Bull Bar & D-rings sold separately.
 
Manufactured from 3/16 cold roll steel
Optional Bull Bar 1.75" .120 wall over rider
Raised corners for better entry and
exit under the most extreme conditions
Solid Mount D-Rings - Welds on the
inside and out!
Built in winch plate to
accommodate up to 15k winch
One-Piece welded design
In built Hi-Lift mount points
Two Stage Textured Matte
Black Finish Powder Coat Finish -
5 year Limited Warranty
Smittybilt Advantage Warranty
Step 2: On the driver’s side of the vehicle, remove the (3) OE steering box bolts. Be sure to support the steering box after unbolting it. (Fig B) Step 3: Install (1) front bumper mount plate (93-7760) to the outside of the frame rail. Secure the mount plate and the OE steering box to the frame rail using the (3) provided 7/16” X 4” bolts and hardware in the OE steering box bolt holes. Install the 1/2” X 3 1/2” bolt, 2” spacer (90-1051 inside the frame) and hardware into the rear most hole in the mounting plate. NOTE: Be sure the (2) front OE bumper mounting plate bolt holes line up with the remaining holes in the front bumper mount (93-7760). (Fig B) (Fig B) Step 4: On the passenger side of the vehicle, install (1) front bumper mount plate (93-7760) to the outside of the frame rail. With the bracket secured in it’s proper position, use the (3) middle holes in the mounting plate as a template, center punch and drill through the outer wall of the frame ONLY! NOTE: Be sure the (2) front OE bumper mounting plate bolt holes line up with the front holes in the front bumper mount (93-7760) before drilling. (Fig C) (Fig C) (3) 7/16” X 4” Bolts (1 Hidden) 1/2” X 3” Bolt & Frame Rail Spacer 93-7760 Bumper Mounting Plate Driver Side (3) Drilled Holes to be Drilled Passenger Side 7/16” Drill Bit 93-7760 Bumper Mounting Plate For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 W Artesia, Compton, CA 90220 Revised 1.31.12 Installation Instructions: Bumper (Part # SB76810) 1984-2001 XJ Jeep Cherokee XRC Front Bumper Step 5: Insert the nut plate (90-7758) into the front opening of the passenger side frame rail. Secure the mounting plate through the frame to the nut plate (90-7758) using the (3) supplied 7/16” X 1 1/4” bolts and hardware. (Fig D) (Fig D) Step 6: Install the 1/2” X 3 1/2” bolt, 2” spacer (90-1051 inside the frame) and hardware into the rear most hole in the mounting plate. (Fig D) Step 7: NOTE: This step might require 2 people. Raise the new XRC front bumper (93- 7761) up into place and align the bumper mounting holes with holes on the bumper mounting plates. Secure using the supplied (6) 10mm X 40 bolts and washers. Insert the (2) 7/16” X 1 1/4” bolts